Airmar NMEA 0183 Manuel d'utilisateur télécharger pdf

Follow the safety precautions below to reduce

the risk of poor product performance, property

damage, personal injury, and/or death.

WARNING: Always wear safety goggles and a dust

mask when installing.

WARNING: The power supply must be OFF before

proceeding with the installation.

WARNING: A safe installation requires a 0.5 amp fast-

blow fuse or circuit breaker. Except WeatherStation

models with a heater require a 3 amp fast-blow fuse or

circuit breaker.

WARNING: The power source must be isolated from

the engine start battery(s). Voltage drops may cause

the instrument/receiver/sensor to lose information

and/or change operating mode.

IMPORTANT: Please read the instructions completely

before proceeding with the installation. These

instructions supersede any other instructions in your

instrument manual if they differ.

Tools & Materials

Safety goggles

Dust mask

Pencil

Electric drill

Drill bit: 3mm or 1/8"

Grommets (some installations)

Cutting pliers

Phillips screwdrivers

Wire strippers

Heat-shrink tubing

Heat gun

Slip-joint pliers

Multimeter

Cable Routing & Connecting Guidelines

CAUTION: To reduce electrical interference from other electrical

wiring and any on-board equipment with strong magnetic fields such

as radar equipment, radio transmitters, engines, generators, etc.,

separate the cables by at least 1m (3'). Ensure that all the cable

shields are appropriately grounded.

CAUTION: Be careful not to tear the cable jackets when passing

them through compartments, bulkheads, or walls. Use grommets

to prevent chaffing.

CAUTION: Use a multimeter to check the polarity and the

connections to the power supply before applying power to the

instrument/receiver/sensor.

Installation

Mounting Location & Hole Drilling

1. Select a convenient dry location for the water-resistant Splitter, a

minimum of 1m (3') from other cables and electronic equipment.

2. Hold the Splitter at the selected location and mark the position

of the four screw holes.

NOTE: If the Splitter will be mounted on a vertical surface, face

the compression nuts downward to avoid any possibility of

water seeping into the box.

3. At the marked locations, drill 3mm or 1/8" holes to a depth of

10mm (3/8"). Do not fasten the Splitter in place at this time.

INSTALLATION INSTRUCTIONS

NMEA 0183 and NMEA 2000

Splitter

For WeatherStation® Instrument

GPS Receiver

Heading Sensor

17-494-02 rev.03 02/27/13

Applications

The Splitter allows the data from the instrument/receiver/sensor

to be shown simultaneously on both an NMEA 0183 device and

an NMEA 2000 networked instrument.

1 2 3 4

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

Follow the safety precautions below to reduce the risk of poor product performance, property damage, personal injury, and/or death.WARNING: Always wea

Page 2 - Connecting

10Preparing the CablesThe Airmar Combination Cable is able to transmit data in both NMEA 2000 and NMEA 0183 formats. The cable can be cut into two par

Page 3

1012345675. Protect each cable’s foil shielding from causing a short circuit inside the Splitter (see Figure 4). Use heat-shrink tubing around the jac

Page 4 - Completing the Installation

Completing the Installation1. From outside the Splitter, pull each cable until only 51mm (2") of jacket remains inside the box. Using slip-joint