Airmar External Diplexer Manuel d'utilisateur télécharger pdf

Tools & Materials

Safety goggles

Dust mask

Pencil

Electric drill

Drill bit 3mm or 1/8"

Grommets (some installations)

Deck gland (some installations)

Phillips screwdrivers

Heat-shrink tubing

Slip-joint pliers

Petroleum jelly (such as Vaseline® brand)

Cable ties

Where to Purchase Parts

Gemeco (USA) Tel: 803.693.0777

Fax: 803.693.0477

email: [email protected]

Airmar EMEA Tel: +33.(0)2.23.52.06.48

(Europe, Middle East, Africa) Fax: +33.(0)2.23.52.06.49

email: [email protected]

Applications

• Converts a dual transmission-line transducer to a single

transmission-line.

• For use with 1 kW echosounders only

Installation

Mounting Location & Hole Drilling

1. Select a convenient, dry, mounting location for the water-

resistant Diplexer, a minimum of 1m (3') from other cables and

electronic equipment.

2. Hold the Diplexer at the selected location and mark the position

of the four screw holes.

NOTE: If the Diplexer will be mounted on a vertical surface,

face the compression nut downward to avoid any possibility of

water seeping into the box.

3. At the marked locations, drill 3mm or 1/8" holes to a depth of

10mm (3/8"). Do not fasten the Diplexer in place at this time.

Cable Routing

1. Route the transducer cable from the transducer to the Diplexer.

Do not connect the transducer cable or fasten it in place at this

time.

2. Route the fishfinder cable from the fishfinder to the Diplexer’s

cable. Do not connect the cables or fasten them in place at this

time.

INSTALLATION INSTRUCTIONS

External Diplexer

Converts dual transmission-line transducer to single line

17-538-01 rev. 02 12/14/10

WARNING: Always wear safety goggles and a dust

mask when installing to avoid personal injury.

CAUTION: To reduce electrical interference from

other electrical wiring and any on-board equipment with

strong magnetic fields such as radar equipment, radio

transmitters, boat engines, generators, etc., separate

the cables by at least 1m (3').

CAUTION: Be careful not to tear the cable jackets

when passing them through bulkheads and other

parts of the boat. Use grommets to prevent chaffing.

Use deck glands to prevent water seepage into the

boat.

IMPORTANT: Please read the instructions completely

before proceeding with the installation. These

instructions supersede any other instructions in your

instrument manual if they differ.

1 2

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

Tools & MaterialsSafety gogglesDust maskPencilElectric drillDrill bit 3mm or 1/8"Grommets (some installations)Deck gland (some installations)

Page 2 - Completing the Installation

ConnectingCAUTION: When the connections are complete, be sure there are no frayed strands, or loose or bare ends to cause shorting.1. Remove the cover

Commentaires sur ces manuels

Pas de commentaire

Airmar External Diplexer Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Airmar External Diplexer. Airmar External Diplexer User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Airmar External Diplexer