Airmar G2183 Spécifications

1 Record the serial number found on the underside of the sensor.Serial No._______________ Date of Purchase____________17-484-01 rev.05 06/12/

102. Decide if you want the cable to exit through the center or along the side of the pole/rail bracket. Slide the nut assembly onto the cable at the

11Flush Mount1. Remove the label from over the sensor unit’s socket (see Figure 3). Apply removable thread locker to the two studs supplied. Screw the

12Cable Routing & ConnectingDepending on the equipment you will be using, route the sensor cable to an Airmar Data Converter, Combiner, an NMEA 01

13No Connector on Display End: WiringIf your sensor cable does NOT have a connector on the display end, it must be hard wired. Referring to the owner’

14Connecting to an NMEA 2000® NetworkCAUTION: Only two termination resistors are required on an NMEA 2000 network. More than two will degrade the bus

15MaintenanceCAUTION: Do not disassemble the sensor. Removing the screws from the sensor unit (part A) will damage the waterproof seal, thus voiding t

1635 Meadowbrook Drive, Milford, New Hampshire 03055-4613, USA www.airmar.com

2All Rights Reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded, or

3Table of ContentsIntroduction... 5Safety Instructions...

4

5IntroductionThank you for purchasing the Airmar’s GPS Receiver and combined antenna. This sensor fixes position using Wide Area Augmentation System (

6Follow the safety precautions below to reduce the risk of poor product performance, property damage, personal injury, and/or death.WARNING: GPS Accur

7Cables & Connecting/Converting HardwareThe GPS Receiver (sensor) can be connected in several ways. You must have the correct cable and any needed

8Choosing the Mounting LocationFor a reliable GPS signal, selecting the best location for the sensor is very important. It can be mounted on a pole, r

9InstallingCAUTION: Be sure to use the correct parts for your installation. Do not use the flush mount parts (gasket, part B) to mount the receiver on